hello@glendalemoldremovalpros.comMon-Fri 7:00 AM-10:00 PM ET | Sat 8:00 AM-10:00 PM ET | Sun 7:00 AM-9:00 PM ET
Home › Blog › Mold in Older Homes in Glendale, CA

Mold in Older Homes in Glendale, CA

The median Glendale home was built in 1966, and about one home in five dates from 1939 or earlier. This guide explains how age, stucco and old plumbing shape the mold story — and what to check first in an older home.

Call Now

Arrange an inspection

Mon-Fri 7:00 AM-10:00 PM ET | Sat 8:00 AM-10:00 PM ET | Sun 7:00 AM-9:00 PM ET

Call Now

TL;DR

The short answer
Older homes grow mold the same way newer ones do — water in the wrong place — but the water gets in through older pipes, older roofs and older stucco.
The number that matters
The median Glendale home was built in 1966 (Point2Homes, from U.S. Census Bureau ACS 2019–2023 estimates).
What to do next
Check the plumbing, the roof and the stucco first — and call to arrange an inspection if you find a sign.
Glendale Mold Removal Pros

The housing stock, in numbers

Glendale's housing stock is the fact that matters most for mold. The median home was built in 1966, and about one home in five dates from 1939 or earlier, from Point2Homes using U.S. Census Bureau ACS 2019–2023 estimates. Close to three in ten homes date from before 1950. The city has about 77,800 housing units, and a large share of them are apartments and condominiums in the downtown blocks, where one leak can reach several units.

The decades tell the story in smaller pieces. The homes from before 1940 are the historic homes of Rossmoyne and Grandview, with plaster walls, old tile roofs and original plumbing. The homes from the 1950s and 1960s are the ranch homes and the apartment blocks that make up much of the city, with galvanized supply lines and cast-iron drains. The homes from the 1970s and 1980s are the remodels and the infill, with drywall over the same old plumbing. Each decade has its own version of the same problem: water finding a way in, and staying there long enough for mold to grow.

Glendale Mold Removal Pros

Stucco, and what it hides

Most Glendale homes wear stucco, and stucco that is cracked or poorly sealed lets wind-driven rain in behind the surface, where it soaks the sheathing and the framing. Santa Ana winds push rain sideways against the walls, and a hairline crack that looks harmless from the street can be the entry point. The growth that follows hides behind the drywall, and the first sign is often a musty smell in the room, not a stain on the wall.

The stucco on an older home has been patched more than once, and each patch is a seam where the water can get in. The inspection checks the stucco for cracks, and the wall cavity for moisture, because the surface gives no sign. A wall that looks dry on the surface can be wet inside, and the meter is what finds it.

Glendale Mold Removal Pros

Old plumbing, and what it does

The plumbing in an older home is the most common source of mold, and the least visible. Galvanized supply lines corrode from the inside, and the corrosion narrows the pipe until it drips at a joint. Cast-iron drains corrode from the inside too, and the crack lets water into the wall cavity or under the floor. The leak is slow, and it runs for months before anyone notices, because the water is inside the wall and the growth is inside the cavity.

The age of the plumbing is not a reason to replace it all at once, and the provider does not say that it is. The plumbing is a question for the plumber, and the mold work follows the plumber's repair. What the inspection does is find the leak, measure how far the water reached, and set out the plan for the mold. The plan covers the mold, not the plumbing.

Glendale Mold Removal Pros

What to check first in an older home

Check the plumbing first: the supply lines under the sinks, the drains, and the water heater. Check the roof second: the flashing around the vents and the chimney, and the tiles that may have slipped in a Santa Ana wind. Check the stucco third: the cracks, the patches, and the seals around the windows. Check the bathroom fan fourth: whether it vents outside, or into the attic. And check the rooms that are used least — a lower room that is used for storage, or a guest room that stays closed — because the growth there has had the longest time to spread.

Glendale Mold Removal Pros

Remodels that hide old problems

A remodel is the moment when the old problems are found, and it is also the moment when the old problems are covered. A bathroom remodel that puts new tile over old drywall, without checking the wall behind it, covers the growth instead of removing it. A kitchen remodel that puts new cabinets over a leaking supply line covers the leak instead of fixing it. The remodel looks finished, and the growth behind it keeps growing.

Glendale's homes are remodelled often, because the housing stock is old and the rooms that show their age first are the ones that get remodelled first. The median home was built in 1966, and the bathrooms and kitchens in those homes have been remodelled more than once. Each remodel is a chance to find the growth, and each remodel is a chance to cover it. The inspection checks the wall behind the tile with moisture readings, because the tile gives no sign.

The right order for a remodel is the inspection first, the mold work second, and the remodel third. The inspection finds the moisture source and the affected area. The mold work removes the growth and dries the cavity. The remodel puts the new tile on a dry wall, with a new seal, new grout, and a fan that vents outside. A remodel done in that order stays clean. A remodel done in the other order grows mold behind the new tile, and the growth is found when the grout turns dark again.

Glendale Mold Removal Pros

The 1960s apartment block

The 1960s apartment block is the building that defines downtown Glendale, and the mold story in it is the story of shared systems. The buildings share the same plumbing runs, the same roof, and the same drainage, and a single failure can reach several units. A supply line fails in one unit and the water reaches the unit below. A roof flashing gap lets winter rain into the top floor, and the water runs down through the units below it.

The buildings are old enough that the plumbing and the roofs have been replaced in pieces, and each replacement is a seam where the water can get in. The inspection checks the units above and below, and the report documents what was found in each. The plan has to cover the units the water reached, not just the one where the growth was seen.

The property manager deals with the pattern across a portfolio, not a single building. The same winter storm finds the same flashing gaps in every building of the same age, and the same old plumbing fails in the same way. The inspection report from the first building becomes the template for the second, and the record travels with the building, from the leak to the repair to the clearance check.

FAQ

Frequently asked questions

Answers from the questions Los Angeles County homeowners actually ask.

Call Now

Older homes grow mold the same way newer ones do — water in the wrong place — but the water gets in through older pipes, older roofs and older stucco. The median Glendale home was built in 1966, and the pipes and flashing of that era have had six decades to wear.

The median Glendale home was built in 1966, and about one home in five dates from 1939 or earlier, from Point2Homes using U.S. Census Bureau ACS 2019–2023 estimates.

Stucco that is cracked or poorly sealed lets wind-driven rain in behind the surface, where it soaks the sheathing and the framing. The growth that follows hides behind the drywall, and the first sign is often a musty smell.

Yes, and it is the most common source. Galvanized supply lines and cast-iron drains corrode from the inside, and the leak runs inside the wall for months before anyone notices. The inspection finds the leak with moisture readings.

The plumbing under the sinks, the roof flashing, the stucco cracks, and the bathroom fan — whether it vents outside or into the attic. And the rooms that are used least, because the growth there has had the longest time to spread.

That is a question for the plumber, not the mold provider. The inspection finds the leak, measures how far the water reached, and sets out the plan for the mold. The plan covers the mold, not the plumbing.

Yes. A new home can grow mold if the grading slopes toward the house, a window well fills in a storm, or a builder-grade vapour barrier fails. The growth follows the water, not the age of the home. The inspection finds the source, whatever the year the home was built.

Galvanized supply lines and cast-iron drains, common in homes built before 1970. Both corrode from the inside, and the leak runs inside the wall for months before anyone notices. The inspection finds the leak with moisture readings.

The work follows the material, not the year. A 1920s plaster wall and a 1980s drywall wall are different materials, and the plan follows the material. Historic homes in Rossmoyne and Grandview carry plaster walls that need a different approach from drywall.

It depends on how far the moisture reached. Plaster that is damp through is removed. Plaster that is dry on the other side is usually left in place. The provider explains the extent before the work starts.

Mold problem in Glendale?

Call now — we will connect you with an independent local provider for an inspection and a clear plan.

Call Now
Contact

Arrange an inspection

Call now and describe what you are seeing and where the property sits. Phone lines are open Monday to Friday 7:00 AM to 10:00 PM ET, Saturday 8:00 AM to 10:00 PM ET, and Sunday 7:00 AM to 9:00 PM ET.

Call Now Email Us
☎ Call Now
Glendale Mold Removal Pros