DIY vs Professional Mold Removal in Glendale, CA
Some mold is a cleaning job and some is a removal job, and the difference decides whether to do it yourself or call a professional. This guide explains how to tell, before you start.
Arrange an inspection
Mon-Fri 7:00 AM-10:00 PM ET | Sat 8:00 AM-10:00 PM ET | Sun 7:00 AM-9:00 PM ET
Call NowTL;DR
- The short answer
- Small surface growth can sometimes be cleaned by the homeowner. Growth behind a wall, under flooring, or larger than about ten square feet needs a professional.
- The test
- If the growth keeps coming back in the same places, the moisture source is still there, and the inspection finds it.
- What to do next
- Look at the size, the place, and the pattern. Then decide — and if in doubt, call to arrange an inspection.
What you can do yourself
Small surface growth on tile, glass or a bathtub can sometimes be cleaned by the homeowner, with the room ventilated and the growth left undisturbed as much as possible. The grout lines are the limit: if the growth keeps coming back in the same places, the moisture source is still there. A bathroom that stays wet will grow mold again, and the cleaning will need doing again, until the fan, the grout or the seal is fixed.
The work you can do yourself is cleaning, not removal. It does not open walls, it does not take out drywall, and it does not dry a wall cavity. It cleans the surface, and it works when the growth is only on the surface. The moment the growth is behind the surface, the job changes, and it is no longer a cleaning job.
What needs a professional
Three things need a professional. The first is size: for areas larger than about ten square feet, the EPA guidance is to hire a professional. The second is place: growth behind a wall, under flooring, in a wall cavity, in an attic, or in a crawlspace is not a cleaning job — it is a removal job, and it starts with an inspection. The third is pattern: growth that keeps coming back in the same places means the moisture source is still there, and the inspection traces it.
The professional job is not a bigger version of the cleaning job. It is containment that keeps spores from spreading, removal of the affected material, cleaning of the surfaces that remain, drying with fans and dehumidifiers, and a clearance check that confirms the area is dry. None of those things happen with a spray bottle.
The risks of doing it yourself
The first risk is the spread. Scrubbing at growth, or tearing out drywall, releases spores into the air, and without containment they travel through the house. The cleaning that was meant to fix the problem in one room creates it in the rooms around it. The second risk is the miss: a wall that looks clean after cleaning can still be wet inside, and the growth inside the material keeps growing. The third risk is the source: a job that does not find the moisture source leaves the growth to return, and the second job is larger than the first.
The fourth risk is the record. In a rental, or a home sale, the inspection report is the record that matters, and a cleaning job does not produce one. The provider's inspection finds the source, measures the affected area, and produces the record. A homeowner's cleaning produces a clean wall and no record.
How to decide
Look at three things. The size: is it smaller than ten square feet, or larger? The place: is it on the surface, or behind it? The pattern: has it come back before, in the same places? If the answer to any of the three is the larger, the hidden, or the returning one, the job is a professional one, and it starts with an inspection. If the answer to all three is the smaller, the surface, and the first time, cleaning may be enough — and if it comes back, the inspection is the next step.
Tools a professional uses that a homeowner does not
The difference between a professional job and a cleaning job is not effort. It is tools. A moisture meter gives a number for each place it touches, and the numbers show what the eye cannot see: a wall that looks dry on the surface can be wet inside. A homeowner without a meter is guessing at how far the water reached, and the guess is usually wrong. The meter is what keeps the plan honest.
Containment is the second tool. Plastic sheeting over the doorways, sealed at the edges, with negative air pressure pulling air into the work area instead of letting it out. It keeps the spores released during removal from spreading through the house. A homeowner without containment spreads the problem to the rooms around it. The containment is what keeps the job in one place.
The drying equipment is the third tool. Fans and dehumidifiers run until the moisture readings in the framing, the subfloor and the wall cavity come down to the level they were before the water arrived. A homeowner with a household fan dries the surface and leaves the inside of the wall damp. The readings are what decide when the drying is done, not the way the wall looks.
When DIY makes the job bigger
Doing it yourself makes the job bigger in three ways. The first is the spread: scrubbing at growth, or tearing out drywall, releases spores into the air, and without containment they travel through the house. The cleaning that was meant to fix the problem in one room creates it in the rooms around it. The second is the miss: a wall that looks clean after cleaning can still be wet inside, and the growth inside the material keeps growing. The third is the source: a job that does not find the moisture source leaves the growth to return, and the second job is larger than the first.
The second job is also more expensive than the first, because the first job has to be undone. The drywall that was torn out without a plan has to be replaced. The flooring that was pulled up has to be re-laid. The growth that spread to the next room has to be removed too. A professional job that starts with an inspection is smaller than a professional job that starts after a DIY job, because the DIY job has already spread the problem.
The record is the fourth way. A cleaning job does not produce a record, and in a rental or a home sale the record is what matters. The provider's inspection finds the source, measures the affected area, and produces the inspection report. A homeowner's cleaning produces a clean wall and no record, and the sale or the dispute has nothing to rely on.
Frequently asked questions
Answers from the questions Los Angeles County homeowners actually ask.
Call NowSmall surface growth can sometimes be cleaned by the homeowner. Growth behind a wall, under flooring, or larger than about ten square feet needs a professional, according to EPA guidance.
The EPA guidance is that an area larger than about ten square feet should be handled by a professional. The size is one of three tests — the others are the place and the pattern.
Because the moisture source is still there. Growth that keeps coming back in the same places means the source — a leak, a vent, a drain, a grade problem — has not been found. The inspection traces it.
No. Tearing out drywall without containment releases spores into the air, and they travel through the house. Removal is done with containment, and it starts with an inspection.
No. A cleaning job does not produce a record. The provider's inspection finds the source, measures the affected area, and produces the inspection report — and the clearance check after the work is the record that the job is done.
When the growth is larger than ten square feet, when it is behind a wall or under flooring, or when it has come back before in the same places. If in doubt, call to arrange an inspection.
Growth that has come back before in the same places, growth behind a wall or under flooring, or an area larger than about ten square feet. Any one of the three means the job is a professional one, and it starts with an inspection.
No. Opening a wall without containment releases spores into the air, and without moisture readings you cannot tell how far the growth has spread. The inspection finds the growth with moisture readings, and the wall is opened as part of the removal work, after the plan is agreed.
A test kit shows what is in the air at the moment the sample was taken, in the room that was sampled. It does not show what is inside a wall cavity, and it does not find the moisture source. The inspection comes first, and testing follows where it changes the plan.
The inspection. The provider visits, checks the rooms and the spaces behind them, takes moisture readings, and finds the moisture source. Nothing is removed before the inspection, because the plan depends on what the inspection finds.
Mold problem in Glendale?
Call now — we will connect you with an independent local provider for an inspection and a clear plan.
Call Now